EasyManuals Logo

Vivotek FD8166 User Manual

Vivotek FD8166
195 pages
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #195 background imageLoading...
Page #195 background image
VIVOTEK
User's Manual - 195
Electromagnetic Compatibility (EMC)
FCC Statement
This device compiles with FCC Rules Part 15. Operation is subject to the following two conditions.
■ This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause undesired
operation.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a partial
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
■ Reorient or relocate the receiving antenna.
■ Increase the separation between the equipment and receiver.
■ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
■ Consult the dealer or an experienced radio/TV technician for help.
Shielded interface cables must be used in order to comply with emission limits.
CE Mark Warning
This is a Class B product. In a domestic environment, this product may cause radio interference, in which
case the user may be required to take adequate measures.
VCCI Warning
この装置は、情報処理装置等電波障害自主規制協議会(VCCI)の基準にづくクラスB情報技術装置
です。この装置は、家庭環境で使用することを目的としていますが、この装置がラジオやテレビジョン
受信機に近接して使用されると、受信障害を引き起こすことがあります。
取扱説明書に従って正しい取り扱いをして下さい
Liability
VIVOTEK Inc. cannot be held responsible for any technical or typographical errors and reserves the right
to make changes to the product and manuals without prior notice. VIVOTEK Inc. makes no warranty
of any kind with regard to the material contained within this document, including, but not limited to, the
implied warranties of merchantability and fitness for any particular purpose.

Table of Contents

Other manuals for Vivotek FD8166

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Vivotek FD8166 and is the answer not in the manual?

Vivotek FD8166 Specifications

General IconGeneral
Total megapixels2 MP
Maximum resolution1920 x 1080 pixels
Supported video modes-
Video formats supportedH.264, M-JPEG
Supported graphics resolutions1920 x 1080 (HD 1080)
Pan range0 - 45 °
White balanceAuto
Tilt angle range33 - 90 °
Angle of rotation360 °
Camera shutter typeElectronic
Camera shutter speed1/32000 s
Minimum illumination0.18 lx
Sensor typeCMOS
Optical sensor size1/2.7 \
Optical zoom48 x
Fixed focal length6 mm
Video motion detectionYes
Flash memory16 MB
Compatible memory cardsmicroSD (TransFlash), SDHC
LED typeIR
Number of illumination LEDs50
CertificationCE, C-Tick, LVD, VCCI
Placement supportedIndoor
Connectivity technologyWired
Form factorDome
Mounting typeCeiling
Product colorWhite
InterfaceRJ-45
Ethernet LAN (RJ-45) ports1
Signal-to-Noise Ratio (SNR)53 dB
Wi-FiNo
Cabling technology10/100Base-T(X)
Supported network protocolsIPv4, IPv6, TCP/IP, HTTP, HTTPS, UPnP, RTSP/RTP/RTCP, IGMP, SMTP, FTP, DHCP, NTP, DNS, DDNS, PPPoE, CoS, QoS, SNMP, 802.1X
Power source typePoE
Power consumption (typical)2.9 W
Operating temperature (T-T)0 - 50 °C
Weight and Dimensions IconWeight and Dimensions
Width90 mm
Height50 mm
Weight144 g

Related product manuals