Vivotek FD8166 - Page 48

VIVOTEK
48 - User's Manual
You can click Restore to recall the original settings without incorporating the changes. When
completed with the settings on this page, click Save to enable the settings.
If you want to congure another sensor setting for the schedule mode, please click Prole to open
the Prole of exposure settings page as shown below.
Activated period:
Select the period of time this prole setting will apply to. Please manually enter
a range of time in a day, fune the Measurement window and Exposure control settings, and then
check Save for the conguration to take effect.
Please follow the steps below to setup a prole:
1. Check Enable and apply this prole to.
2. Enter enter a range of time.
3. Configure Exposure control settings in the
folowing columns. Please refer to previous
dicussions for detailed information.
4. Click Save to enable the setting and click Close
to exit the page.
2013/3/5/ 04:03:54