49
The AutoStim Diagnostics test determines if the generator is able to deliver the
programmed AutoStim output current. The desired AutoStim output current
should be programmed before you perform the diagnostic test.
The Generator Diagnostics test is designed specifically for use with a test
resistor and should only be accessed for troubleshooting scenarios during
implantation surgery. Go to “Troubleshooting” for more details on using
Generator Diagnostics.
NOTE:
Once programmed ON, lead impedance measurement readings are
automatically performed once every 24 hours for Model 103 and
higher generators. Results from the 24-hour impedance check will be
reported on the Summary Screen upon initial interrogation.
AutoStim Diagnostics
Generator Diagnostics
To Next Page
Loading...