Model DMTC22KW
Domestic Charger AC 22kW
→ Select the option “Charger Monitor” and “Always”.
⇒ Controller Setting: The menu below is for maintenance purposes ONLY. DO NOT
change the following settings without instructions from qualified personnel.
→ Check the box before “ReadBoard” for Firmware version information;
→ To switch between the two loading plates of the model with two output
sockets, click on the content field “1”;
→ Click “Back” to return to the initial configuration menu;
→ For any other advanced settings in this menu, consult qualified service
personnel.
→ DO NOT change any default value without consulting qualified technicians.
Inappropriate changes can lead to the failure of the Station.
To Next Page
Loading...