Model DMTC22KW
Domestic Charger AC 22kW
→ Configure the module – After inserting the SIM card, and replacing the module
back in the device, it is necessary to configure its APN (Access Point Name). This may
vary depending on the operator that offers the mobile data service. Or, if applicable,
according to the MOBI.E parameters provided for the installation of the station.
⇒ Connect a PC to the module via Ethernet cable – Disconnect the RJ45 network
cable from the Android controller module (Display) and connect it to your laptop. In
this way, he connected the 3G / 4G module to his personal computer.
⇒ Ensure connectivity – Check in your personal computer settings that the Ethernet
network interface is connected.
⇒ Connect to the module – Use a browser of your choice to connect to the module.
VOLT-E carried out its tests with the Chrome browser. And type the following address
in the respective bar http://10.10.100.254.
Use the word admin, as user and password.
⇒ Main screen – After the connection is established, the following screen should be
displayed.
To Next Page
Loading...