123456789012345678901
123456789012345678901
123456789012345678901
123456789012345678901
123456789012345678901
50 Hrs
250 Hrs
500 Hrs
1000 Hrs
2000 Hrs
12 months
Close sea cock. Remove cover (1) and lift up insert. Clean insert and housing
(2). Reinstall parts. Open sea cock and check for leaks.
Use protective goggles! Battery fluid approx. 10 mm (0.39") over cell plates.
WARNING! The batteries contain oxyhydrogen gas and extremely corrosive
sulfuric acid. Naked flames/sparks close to batteries may cause an
explosion.
Add 1/2 liter anti-corrosion agent to the freshwater system (P/N 1141526-2).
NOTE! : Only when glycol is not used in the cooling system.
Close sea cock and drain the water from the seawater and freshwater systems.
Flush via holes for drain cocks and plugs until clean water runs out.
Close sea cock and drain the water from the seawater and freshwater systems.
See also instructions on pages 56 – 58.
Close the sea cock and drain the water from the seawater system. See also
instructions on page 59.
●
●
●
●
●
●
56
67
20
28,
55
28,
56
28,
59
18. Check/clean seawater
filter.
NOTE! The time must be judged by
experience after running the engine for a
while.
19. Check batteries.
20. Top up anti-corrosive
agent in freshwater
system.
21. Clean cooling system.
Change coolant.
22. Check/clean heat
exchanger, charge air
cooler (CAC), and
reverse gear oil cooler.
23. Check/replace pump
impeller in seawater
pump and any extra
bilge pump.
No. Action Instructions Info.
pge.
To Next Page
Loading...