23
Pressing #1 at this point will return you to the first menu.
Note: Press *0 to exit remote operation mode. In addition, the gz 2456 will exit remote
operation mode if there is approximately 15 seconds of inactivity after the voice prompt.
Review of Remote Commands
• “ Press #2 to play all the messages” The system will announce how many new and
old messages are in memory. If there are any new messages, press #2, the gz 2456 will
play the new messages only. Once all new messages are played, you can press #2
again to play all (old) messages.
• “Press #5 to stop” Press #5 during review of messages to stop playback; press #5 to
end MEMO and Outgoing Message Recording.
• “Press #4 to repeat the message” During message review, press #4 to return to the
beginning of the message being played. Press #4 twice to return to the previous message.
• “Press #6 to skip the message” During message review, press #6 to skip to the next
message.
• “Press #9 to delete the message” During message review, press #9 to erase the
message being played.
• “Press *7 to record outgoing message” To record a new outgoing message
(replacing the previous outgoing message), press *7. When your outgoing message is
completed, press #5, or hang up.
• “Press #0 to turn system on or off” As you press #0 , the voice prompt will toggle
between “ Answering machine on” and “Answering machine off”.
• “Press #7 to review outgoing message”
• “Press *8 to record memo” As you press *8 , the voice prompt will announces “ Now
Recording”. When your memo is completed, press #5, or hang up.
Your gz 2456 Handset is equipped with a 2.5mm Headset Jack for use with an optional
accessory Headset for hands-free operation. If you choose to use the Headset option,
you must obtain an optional accessory Headset, which is compatible with the gz 2456.
Remote Operation of the gz 2456
To Next Page
Loading...
