26
IN CASE OF DIFFICULTY
• If the buttons don’t work, try placing the handset in the Base for at least 15 seconds.
If you hear other calls while using your phone:
• Press CHAN to change to another channel.
• Disconnect the Base from the modular jack and plug in a corded telephone. If you still
hear other calls, the problem is probably in your wiring or local service. Call your local
telephone service company.
If you lose a call after changing channels:
You were probably almost out of range. Move closer to the Base before changing channels.
Before placing another call, set the Handset in the Base for at least 15 seconds.
If you are unable to operate special telephone services or other equipment requiring
touch tone signals:
If you have dial pulse (rotary) service, follow the directions under “Temporary Tone Dialing”
in the TELEPHONE OPERATION section of this manual.
Your answering system is not recording messages
• Make sure the system is turned ON (the ON/OFF key is illuminated).
• Make sure Announce Only feature is set to OFF.
You cannot hear recorded messages
• Using the Base volume control, raise the volume to a comfortable listening level.
As you adjust the volume, the Message Window will dispaly the level (1-8).
CL is flashing in the Message Window
• You need to set the day and time. See Set Day and Time for details.
To Next Page
Loading...
