VWR Puranity TU+ | 41
Operating elements
A =Display shows the actual value of final product water resistivity/ conductivity and temperature.
If the measurement range end value is exceeded (>199 µS/cm or >0.005 MΩ·cm),
then ÷ 200 is shown in the display.
B = Second line shows the currently running measurement mode in µS/cm, MΩ·cm and °C.
C = Third line shows the “Limit value Cond.“, “Temp.“and “Status Sensor“. The “Limit value
Cond.“ LED‘s will report any value, out of its limit, immediately. Also the calling up of
submenus for limit settings is indicated. The “Status Sensor“ LED shows any error at the
conductivity and temperature measuring cell.
To Next Page
Loading...