VWR Puranity TU+ | 43
System control
Menu
The menu consists of three sub-points:
1. Switching to dual mode together with selection of the measurement unit for the conductivity
measurement.
2. Setting the product water conductivity limit value.
3. Setting the temperature limiting value.
Mono/dual measurement mode
NOTE!
This following combinations are possible in the Mono/dual measurement mode:
adjusted resistance value MΩ·cm: “c” and “ct”
adjusted resistance value µS/cm: “c” and “ct”
Mono measurement mode:
In this mode only the conductivity is displayed. The temperature can be read when the
“Enter” button is pressed.
Dual measurement mode:
In this mode, temperature and conductivity are shown alternating in a 2-second tact.
The LED for the unit switches with the display.
To Next Page
Loading...