EasyManua.ls Logo

Wacker Neuson 28Z3

Wacker Neuson 28Z3
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
OM 28Z3 US – Edition 2.0 * 28Z3b530.fm 5-28
Maintenance
Every week
Check once a week:
Electric fuses see chapter Fuse box in engine compartment on page 6-3
Cable and earth connections
Battery charge condition – see Battery on page 5-29
Condition of battery terminals
Instructions concerning specific components
Cables, bulbs and fuses
Always observe the following instructions:
Malfunctioning components of the electric system must always be replaced by a
qualified technician.
When performing maintenance work on the electric system, pay particular attention to
ensuring good contact in leads and fuses.
Blown fuses indicate overloading or short circuits. The electric system must therefore
be checked before installing the new fuse.
Only use fuses with the specified load capacity (amperage) see chapter Fuse box in
engine compartment on page 6-3.
Alternator
Always observe the following instructions:
Only test run the engine with the battery connected.
When connecting the battery, make sure the poles (+/–) are not inverted.
Always disconnect the battery before performing welding work or connecting a quick
battery charger.
Replace a malfunctioning charge indicator light immediately see chapter 31 Indicator
light (red) – alternator charge function on page 3-10

Table of Contents

Other manuals for Wacker Neuson 28Z3

Related product manuals