EasyManuals Logo

Wacker Neuson BS 50-4 Repair Manual

Wacker Neuson BS 50-4
156 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #31 background imageLoading...
Page #31 background image
Repair Engine and Upper Machine Components
wc_tx001546gb.fm 31
4.3.6 Remove the throttle lever (c) from the machine.
Result
The removal procedure is now complete.
Installation
Perform the procedure below to install the throttle control.
4.3.1 Connect the throttle lever (c) to the machine with bolt (h) and
hardware (b). Adjust the nut on the throttle control lever so that the
lever moves freely but still holds its position while the rammer is
operating. The recommended torque value is 2.9 Nm (2.1 ft.lbs.).
4.3.2 Connect the throttle cable to the machine at point
(g).
4.3.3 Support the throttle cable with new wire ties
(d).

Table of Contents

Other manuals for Wacker Neuson BS 50-4

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Wacker Neuson BS 50-4 and is the answer not in the manual?

Wacker Neuson BS 50-4 Specifications

General IconGeneral
Engine ManufacturerHonda
Stroke Height65 mm
Fuel TypeGasoline
Centrifugal Force15 kN
Sound Pressure Level92 dB(A)
Sound Power Level105 dB(A)
Height965 mm
Ramming Shoe Size280 mm
Tank Capacity3.1 l
Fuel Tank Capacity3.1 l
Engine Type4-cycle, single-cylinder, air-cooled
Percussion Rate680 blows/min

Related product manuals