Wacker Neuson DPU130Le User Manual

DPU 130Le 10 Troubleshooting
Operator's manual
96
17 IR transfer
Wrong address
Wrong transmission channel set
on remote control.
Coordinate the transmission
channel between the remote
control and the machine.
18 Machine
Cooling...
Coolant level is too low. Top up coolant.
Motor is overheated. Let engine cool off.
Radiator cooling fins are dirty. Blow out cooling fins from inside
to outside with compressed air
at a sufficient distance.
Cooling system has a leak. Have the machine repaired. *
Temperature sensor is
defective.
19 Machine
Excess temp.
Coolant level is too low. Top up coolant.
Motor is overheated. Let engine cool off.
Radiator cooling fins are dirty. Blow out cooling fins from inside
to outside with compressed air
at a sufficient distance.
Cooling system has a leak. Have the machine repaired. *
Temperature sensor is
defective.
20 Error
Temp. sensor
Temperature sensor or
electrical connection is
defective.
Have the machine repaired. *
At very low temperatures the
coolant will not reach the
required temperature of 55 °C
in the warmup phase. The
machine will cancel the warmup
phase but will be ready for
operation.
—
21 Error
Automatic start
Fuel tank is empty.
Top up with fuel.
 Defect in fuel system.
 Motor, diesel valve or
electrical connection of the
diesel valve is defective.
Have the machine repaired. *
22 Error
Charge cont./St.
Charge control, starter, or
electrical connection is
defective.
Have the machine repaired. *
23 Error
Diesel valve
Diesel valve is defective.
Machine cannot be turned off.
Have the machine repaired. *
Error
code
Display screen Cause Remedy

Wacker Neuson DPU130Le Specifications

General

Brand	Wacker Neuson
Model	DPU130Le
Category	Power Tool
Language	English