4-16 BA ET18, 20, 24 en* 1.5 * et18_20_24i400.fm
4 Putting into operation
Adjusting the mirrors
Adjust the mirrors in order to:
• Ensure sufficient visibility from the operator seat onto the job site.
• Ensure maximum visibility to the rear.
• Ensure visibility of the rear left edge of the machine in the left mirror.
• Ensure visibility of the rear right edge of the machine in the right mirror.
Set the machine to drive position before adjusting the mirrors – see “Drive
position” on page 5-3.
We recommend having the mirrors adjusted by a second person.
Do not make any changes or modifications that impair visibility. Otherwise
the machine does not meet the requirements for conformity and
registration.
Fig. 83Adjusting the outside rearview mirrors
To Next Page
Loading...
