Wacker Neuson ET65 - Page 163

BA E14 track en* 1.3 * E14t_13_510.fm 5-35
Operation 5
Perform a functional check of the control lever base.
– see chapter “ Functional check of control lever base” on page 4-54
Only the following lifting gear may be used for lifting gear applications:
• Powertilt/quickhitch with load hook
• Joint rod with lifting eye
When symbol A is displayed and the buzzer sounds:
• Reduce the load until the buzzer goes out and the symbol disappears.
Suitable equipment for fastening and securing loads must be available.
Fig. 184
A
Warning devices Result
The buzzer sounds and sym-
bol A is displayed
The vehicle may be used for lifting gear
applications.
Buzzer does not sound or
symbol A is not displayed
The vehicle may not be used for lifting
gear applications. Contact a
Wacker Neuson service center.
Fig. 185
Fig. 186
A