GPi
3200/4300
Operation
4.13 Grounding the Generator
Location The ground lug (d) is located to the right
of
the DC terminals.
Function
Connection
wc_tx001875gb.fm
wc_gr006664
This ground connection is used for electrically grounding the generator when
necessary to
comply with the National Electrical Code and other federal, state, and
local regulations. For grounding requirements
in
your area, consult with a qualified
electrician, electrical
inspector, or local agency having jurisdiction over electrical
compliance.
• If
the generator is used at a construction site, there may be additional
regulations which must be observed.
• In some areas, generators are required to be registered with local utility
companies.
Connect the ground
lug to a good earthen ground for proper operating safety
in
compliance with NEC and local standards. The following options may be used:
• Connect the ground lug to a grounding spike (w) and drive the grounding spike
into the earth.
• Connect the ground lug to
an
existing grounded conductor.
35
W.\CKEit
NEUSON
To Next Page
Loading...
