21
Control 150 M
GB
g) This appliance is not intended for use by persons
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience
and knowledge, unless they have been given
supervision or instruction concerning use of the
appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
h)
Do not lull yourself into a false sense of security
and do not think yourself above the safety rules
for electric tools, even if you are familiar with
the electric tool following extensive practical
experience. Careless use can lead to serious injuries in
fractions of a second.
4. Power tool use and care
a)
Do not force the power tool. Use correct power tool
for your application. The correct power tool will do the
job better and safer at the rate for which it was designed.
b)
Do not use the power tool if the switch does not
turn it on and o. Any power tool that cannot be
controlled with the switch is dangerous and must be
repaired.
c)
Disconnect the plug from the power source and/
or the battery pack from the power tool before
making any adjustments, changing accessories, or
storing power tools. Such preventive safety measures
reduce the risk of starting the power tool accidentally.
d) Store idle power tools out of reach of children and
do not allow persons unfamiliar with the power
tool or these instructions to operate the power tool.
Power tools are dangerous in the hands of untrained
users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may aect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f)
Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
dierent from those intended could result in a hazardous
situation.
g) Keep the handles and grip surfaces dry, clean and
free of oil and grease. Slippery handles and grip
surfaces hamper safe operation and control of the
electric tool in unforeseen situations.
5. Service
a)
Have your power tool serviced by a qualied repair
person using only identical replacement parts. This
will ensure that the safety of the power tool is maintained.
b) If the supply cord is damaged, it must be replaced
by the manufacturer or it’s service agent or a
similarly qualied person in order to avoid a safety
hazard.
Health protection
Caution! Wear breathing equipment: Paint
mist and solvent vapors are damaging to
health. Always wear breathing equipment
and only work in well ventilated rooms
or using supplementary ventilating
equipment. It is advisable to wear working
clothing, safety glasses, ear protection
and gloves
Flammable materials
Do not use the spray guns to spray
ammable substances.
Explosion protection
Do not use the unit in work places which
are covered to the explosion protection
regulations.
Danger of explosion and re through
sources of ame during spraying work
There may be no sources of ame such
as, for example, open res, smoking
of cigarettes, cigars or tobacco pipes,
sparks, glowing wires, hot surfaces, etc.
in the vicinity.
Electrostatic charging (formation of
sparks or ame)
Under certain circumstances, electrostatic
charging can occur on the unit due to
the rate of ow of the coating material
when spraying. On discharging this can
result in the emergence of sparks or re.
It is therefore necessary that the unit is
always earthed through the electrical
installation. The connection must take
place through a correctly earthed two-
pole-and-earth socket outlet.
Ventilation
Good natural or articial ventilation must be ensured in
order to avoid the risk of explosion or re and damage to
health during spray work.
To Next Page
Loading...
Need help?
General
