What if there is foreign body in suction valve of WAGNER Leopard 35-70 Water Pump?
If there is a foreign body in the suction valve of your WAGNER Water Pump, dismount the suction valve housing, and clean and check the valve seat.
What to do if WAGNER Leopard 35-70 does not work and there is no pressure indication?
If the WAGNER Water Pump isn't working and there's no pressure indicated on the pressure gauge, it could be that the air pressure regulator is defective. Try briefly disconnecting the compressed air supply. If that doesn't work, you may need to repair or replace the pressure regulator.
Why is my WAGNER Leopard 35-70 Water Pump spray jet collapsing?
If your WAGNER Water Pump's spray jet collapses, causing pulsation, it might be due to several reasons. One possibility is that the viscosity of the spraying product is too high; in this case, thin the spraying product. Another reason may be that the spraying pressure is too low, so you should increase the incoming air pressure or use a smaller nozzle. Also, check if the valves are clogged, and if so, clean the pump, soaking it in cleaning agent if needed. Ensure that the control air filter or work air filter is not clogged, and clean it if necessary.
What to do if WAGNER Leopard 35-70 runs but does not suck up any product?
If the WAGNER Water Pump runs evenly but doesn't suck up any product, the issue might be a loose union nut in the suction system, causing the pump to take in air. Tighten the union nut to resolve this. Another potential cause is a clogged suction filter, which you should clean. Also, check if the ball in the suction or piston valve is stuck; if so, clean the balls and valve seats.
What to do if WAGNER Water Pump is working with a closed spray gun?
If the WAGNER Water Pump is working even when the spray gun is closed, it indicates that packings, valves, or pistons are worn out and need replacement.
What to do if there is no pressure on my WAGNER Leopard 35-70 Water Pump?
If there is no pressure indication on the pressure gauge of your WAGNER Water Pump (and the air pressure regulator might be defective), briefly disconnect the compressed air supply or repair or change the pressure regulator.
Explanation of warning instructions, categories, and their meanings.
Information on using the device in explosion hazard zones.
Details ATEX directive compliance and device suitability for explosive areas.
Essential safety guidelines for the person operating the device.
Safety guidelines for all personnel involved with the device.
Explanation of how the piston pump operates.
Details on safety features and monitoring devices.
Graphical representations of pump performance characteristics.
Step-by-step instructions for assembling and installing the pump system.
Procedures for grounding the device and system components.
Pre-commissioning checks and procedures for starting the device.
Procedure for immediate shutdown in case of unforeseen occurrences.
Procedure for safely relieving pressure before or during work.
Instructions for regular flushing to maintain pump performance.
Procedure for filling the pump with the actual working product.
Procedures and safety for cleaning the device and its components.
Guidelines for maintenance personnel and instructions for upkeep.
Requirements and safety for personnel performing repairs.
Crucial safety warnings and procedures before starting repairs.
Information required for ordering the correct spare parts.
Safety warnings and guidelines for using spare parts.
General| Voltage | 230 V |
|---|---|
| Frequency | 50 Hz |
| Maximum flow rate | 7000 l/h |
| Maximum head | 7 m |
| Max Flow Rate | 7000 l/h |
To Next Page
