88
EN
Display console
1. Insert the 5V AC adaptor into the back of the display console
Note: Place the outdoor sensor array about 5 to 10 feet from the display
console and wait several minutes for the remote sensors to synchronize
with the display console.
2. Insert 3 AAA batteries into the display console。Please insert the battery
as blew gure 12.
12
Note: The batteries are intended for back-up power only. The backlight
will remain on for 5 seconds when on back up battery power only. Only
when you use power adapter it will the back-light be continuously on.
3. Keep both sensor and the display console together for 15 minutes to lock
in the sensor signals.
4. Spin the wind cups to simulate wind speed. Take the sensor to the sink and
slowly drip water into the rain bucket to simulate rain.
5. After 15miuntes, follow the mounting instructions for proper placement
of sensors.
To Next Page
Loading...
Need help?
General
