5
Connector Recommendations
Important information for the correct disposal of the product in accordance with Directive
2012/19/EU. At the end of its useful life, the product cannot be disposed of as urban waste.
It must be taken to a collection centre for special and dierentiated waste or to a distributor that
provides this service.
• Always check the charging cable and the contacts for damage and contamination before use.
• Never use a charging cable, the vehicle plug, or the infrastructure electrical outlet to charge if any of them
are damaged.
• Never use contacts that are dirty or wet.
• Only connect the connector to vehicle plug and infrastructure electrical outlets that are protected
against water, moisture and liquids.
• After stopping the charging process, the vehicle connector and the equipment plug can be
disconnected. Never use force to disconnect the vehicle connector from the inlet or the equipment
plug power outlet. Doing so is dangerous and may cause serious injuries or even death.
• Depending on the charging station and the electric vehicle, the time to complete the charging
process and the unlocking may vary.
• Some vehicles can be started with the charging cable connected. Be sure to unplug before
driving away.
• Do not use the charging cable with an extension cable or an adapter.
• If the connector emits smoke or begins to melt, do not touch the charging cable under any
circumstances. If possible, stop the charging process. In all cases, disconnect the power supply from
the Wallbox device.
• Keep the charging cable out of reach of children.
• Be careful with the connector, do not step on it or on the cable.
• The cable should NOT be tightened under ANY CIRCUMSTANCES while connected to the vehicle.
To Next Page
Loading...
