40
If you don’t have another Wi-Fi network available, you can create a Wi-Fi network with your mobile phone
data using a Wi-Fi hotspot.
Please note that tethering might or might not be be included in your plan as a part of your data allowance.
Additional data consumtion might result in additional cost.
Make sure to contact your mobile service provider for additional details.
Wi-Fi network disconnections
If the charger has lost its Wi-Fi connection, simply restart your Wallbox Quasar and it will automatically
reconnect.
Check your Wi-Fi modem as well to make sure it is functioning properly.
iPhone (iOS 13):
1. Settings
2. Mobile Data
3. Personal Hotspot
4. From the charger select the
hotspot you created with your iPhone
Android 10:
1. Settings
2. Network & Settings
3. Hotspot & tethering
4. Wi-Fi hotspot
5. Select on
6. From the charger select the
hotspot you created with your
Android phone.
• Connect using dierent Wi-Fi Network.
If you don’t have another Wi-Fi network available, you can create a Wi-Fi network with your mobile
phone data using a Wi-Fi hotspot. Here are the instructions on how to do so with your phone:
Warning messages
Your power supply is constantly checked by the Wallbox in order to ensure safe operation. If one of the
parameters is outside the correct operating range, the Wallbox will not allow you to charge your vehicle
and will show you a warning message on the screen:
Unavailability of the charging station:
• Turn o the circuit breaker and wait a few seconds before turning it back on.
• If this doesn’t work then consult with your installer to make sure that the current selector is not at
position 0.
No power to the charging station:
• Disconnect the charging cable from the vehicle. Then turn o the circuit breaker, wait 10 seconds,
then turn the circuit breaker back on. Then reconnect the charging cable to the vehicle.
To Next Page
Loading...
