WAM SILOTOP zero - 5.3 Electronic board - connections and settings; 5.4 Electrical connection

5.0 INSTALLATION AND FIXING
2
FIL.SILOTOP_zero.--.M.A4.0722.EN Issue: A4
07.22
21
5.3 Electronic board - connections and settings
For the electrical connection and settings of the new Filcontrol time and Filcontrol Connect electronic boards,
refer to the related manual (le name ELECTRONIC BOARDS FILCONTROL - it.pdf) available in the Down-
load section of the page dedicated to the WAMFLO Flanged Round Dust Collectors on wamgroup.com.
fax
e-mail
internet
+ 39 / 0535 / 618111
+ 39 / 0535 / 618226
info@wamgroup.com
www.wamgroup.com
WAMGROUP S.p.A.
Via Cavour, 338
I-41030 Ponte Motta
Cavezzo (MO) - ITALY
ASSEMBLY
INSTRUCTIONS
063002705 Revision: A3 Latest update: April 2022
ORIGINAL INSTRUCTIONS IN ENGLISH
FILCONTROL
TIME &
FILCONTROL
CONNECT
ELECTRONIC CONTROL BOARDS
EN
5.4 Electrical connection
Danger - Warning
The equipment is not provided with an electrical system.
Connection to the mains has to be carried out by an electrician.
Provide mains supply to the equipment concerned according to the compliant current legislation and
take into consideration the safety measures required by the installation environment and the envis-
aged operating conditions.
Before carrying out the connection ensure that the mains voltage and frequency correspond to those
indicated on the electric motor rating plate. Disconnect from the mains before carrying out any work
and use suitable devices so that there cannot be an accidental reconnection.