6.0 INFORMATION REGARDING USE
2
FIL.SILOTOP_zero.--.M.A4.0722.EN Issue: A4
07.22
29
6.1 Production Start-up
Before starting up the lter, the operator in charge and authorized for the production must ensure the safety
devices installed are present and working and the operating conditions are followed (hatches closed, inlet and
outlet spouts connected correctly o protected, etc.).
Start-up procedure
After having completed the preliminary checks, carry out the start-up procedure as follows:
1) Start up the dust discharging equipment (if provided).
2) Start up the air compressor.
3) Power up the electronic board (MS LED On).
4) Start up the cleaning cycle (CLEAN LED On).
5) Make sure all the solenoid valves work correctly (the yellow led lights up when the board sends the pulse
to the solenoid valve).
6) Check the blow duration and the interval between one blow and the next.
N.B.: If the lter features a FILCONTROL CONNECT electronic board, in case the solenoid valves are not
acknowledged, the board displays the message ERR01.
Once the lter is installed, it is necessary to check the cleaning cycle, especially in the rst few weeks of
operation.
Only through these checks it will be possible to determine whether the pre-set pause duration is the proper one
as regards the cleaning of the lter cartridges.
Important
In case of excessive noise, strong vibrations, etc. stop the equipment and report the problem to the
person in charge authorized to restore the correct working.
Do not use the equipment if damaged.
6.2 Machine shut-down at the end of the work cycle
1) Shut down the lter without disconnecting it from the power supply (according to the settings of the board,
the end of cycle cleaning gets automatically enabled on the basis of the number of cycles pre-congured
on the electronic board.
2) At the end of the cycle, disconnect the actuator from the power supply.
3) Shut down the air compressor.
4) Start up the dust discharging equipment or screw conveyor (if provided).
To Next Page
Loading...