The PrimeLab 2.0
*Make sure to align the arrow on the side of the 16mm adapter, with the arrow of the measurement
chamber. If the adapter cannot be turned smoothly or only with high force, please put a small drop of
silicon-grease on the edge of the transparent part of the measurement chamber.
Your PrimeLab 2.0 works with different vial sizes, such as round 24mm, 16mm and rectangle 1ml
semi-micro-vials (rectangle), each needing a different vial-adapter. To ensure a perfect fit of the
specific vial-adapter, please follow the instructions below, showing you how to change to a different
adapter: Unlatch the adapter installed by turning it 90° counter clockwise to be able to take it out.
Enter the adapter by placing it on the transparent measurement-chamber and turn it until you feel it
slides in position. Then turn it 90° clockwise until you feel/hear a click. Make sure the adapter does
not wiggle.
Vial-adapters
However, we offer interchangeable plugs for e.g. Europe, UK and Australia that can be slid over the
USA socket. For the fastest charging results, connect the charger to the PrimeLab 2.0 while the
PrimeLab 2.0 is switched on. Switch on your PrimeLab 2.0 off after plugging it in to charge.
Your PrimeLab 2.0 has a powerful lithium-ion battery that can be charged with the supplied DC
adapter plus USB cable. The PrimeLab 2.0 can be charged with any USB charging adapter and
cable. However, we recommend using the supplied power adapter and cable as this allows the unit
to be charged in fast charging mode. The DC adapter has a 2-pin built-in plug, suitable e.g. for the
USA.
Charging the battery
*It is possible that there is no arrow on the adapter yet. This will only appear on upcoming
models. If your model does not have a triangle, please make sure that the arrow on the device
points to the elevation on the side of the adapter.
More about the charging procedure and the adapters of PrimeLab 2.0
on our YouTube channel:
Scan me
10
PrimeLab2.0
To Next Page
Loading...
Need help?
General
