The "Connections" menu allows you to edit the WiFi and Bluetooth® settings. An internet connection
is necessary to communicate with the LabCOM® cloud (synchronizing sampling points,
measurements and water treatment chemicals), to receive updates and for automated online
activation of additional test-parameters.
An internet-connection can be established by Wi-Fi or by a GSM-modem*.
• Tap on Wi-Fi: A list of available Wi-Fi networks will be displayed. If Wi-Fi is activated and a Wi-Fi
connection is established, the paired network will be displayed in blue.
• Enable or disable Wi-Fi connection by tapping the green/red point.
• To delete a network which was previously paired, slide the network line to the left and tap the delete
symbol.
GSM*:
• To add a WiFi connection, tap on Wi-Fi followed by tapping one of the networks found. Then enter
the network-password in the password field and confirm.
Internet connections established via the USB-port (e.g. GSM-stick*) can‘t be managed under
‘Settings‘. The connection establishes automatically, once a GSM-modem with valid SIM-card was
plugged into the USB-port.
Your PrimeLab 2.0 also offers a Bluetooth®-connection which, by the date of printing this manual, is
without use. To manage connections, tap on the ‘Connections‘ symbol from the ‚Settings‘ menu.
Connections
• Adjust the brightness of your display (influences the battery time)
• Define an individual home screen graphic
• Set the auto-display-off time (after what time the display shall be switched off)
• Activate/deactivate display dimming. If display dimming is active, the screen automatically
becomes a few levels darker after 30 seconds. After tapping the screen, it becomes bright again.
Under ‘Display‘ on the ‘Settings‘ menu, you can:
• Set the auto-power-off time (after what time the PrimeLab 2.0 shall shut down)
• Activate / deactivate the screensaver (after 30 sec. inactivity)
Display
Settings
Continued...
26
PrimeLab2.0
⚙
To Next Page
Loading...
Need help?
General
