21
Settings
To open the ‘Settings‘ menu click on the settings icon in the ‘Main Menu‘.
Continued...
*via USB Internet Stick / accessories / may be subject to costs for connection
• To delete an operator, swipe the operator‘s name to the left, followed by a tap on the delete button.
Each measurement file does not only show the test result in connection with the tested sampling
points plus time stamp, but also the operator who conducted the test. When receiving your
PrimeLab 2.0, there already is a ‘Default‘ operator in place, but you can add as many operators as
you like.
• Tap on “Operator” in the ‘Settings‘ menu
• To add an operator, either tap on ‚+‘ or the 3-bar menu button followed by ‘Add Operator‘ and insert
all required data. Once done, tap the ‚save‘ button.
• To edit an operator, swipe the operator‘s name to the right, followed by a tap on the edit button.
You can also tap-hold an operator‘s name followed by tapping additional ones. A delete button will
appear at the lower end of the display.
• To switch between operators, simply tap on the tick-box on the right side of the operator‘s name.
For subsequent measurements, this operator will then be saved together with the measurement
data.
• To search for an operator, simply tap the 3-bar menu button, followed by a tap on the search button.
Then enter (part of) the operator‘s name you are searching for.
Operators
Calibration
If you receive an error message 'calibration failed' , please refer to the ERROR section at the
end of this chapter.
• Tap on "Settings" --> "Calibration and Indexing" to open the calibration menu.
• Select the calibration procedure you want to carry out by tapping on one of them:
PrimeLab
PTSA
NTU-Turbidity
Because of the innovative PrimeLab technology, it is no longer necessary to return the photometer
for calibration. The precision of the sensors is so good, that the strength of the light source (LED) is
measured and the system is calibrated on basis of the measured LED-values. Calibration should be
carried out on a regular basis (e.g. every month) to ensure accurate test results at all times.
Nevertheless, some special water-parameters, such as NTU-Turbidity, require a special calibration
procedure which influences the measurement curve installed on your PrimeLab 2.0.
Tap on "Measurement settings" to activate the professional mode or to adjust the signal intensity of
iron in oil. When the professional mode is active, the animated step-by-step instructions are no
longer displayed during measurements. To reactivate the animations and instruction texts, please
deactivate the professional mode.
Measurement settings
PrimeLab2.0
⚙
To Next Page
Loading...
Need help?
General
