35
QR-Scanner / Camera
The in-built camera of the PrimeLab 2.0 is designed to make your life easier by scanning QR-
codes. So far, PrimeLab 2.0 offers three options to scan QR-codes:
• Reagents
• Sampling points
• Activation codes
Once created, printed and held available at the sampling point, all you need to do is to scan the QR-
code to immediately launch a measurement procedure where this sampling point will be already
pre-selected. PrimeLab 2.0 offers two options to pre-select the sampling point to be measured,
using the in-built camera:
• Tap on the camera symbol on the main menu and scan the QR-code of the sampling point. The
‘Test‘ menu will appear instantly, with the scanned sampling point pre-selected.
As PrimeLab 2.0 always saves test results in conjunction with a sampling point, the test process
starts with selecting the sampling point for which you intend to perform the following measurement.
As long as your database is connected to the LabCOM® cloud (see ‘Cloud‘ menu), you will be able
to generate and print QR-codes of each sampling point under www.labcom.cloud and have it ready
near the water site, to scan it.
• Start a test procedure by tapping the ‘Test‘ icon on main menu, then tap the camera symbol next to
the sampling point field, followed by scanning the QR- code of the sampling point.
Scanning Sampling Point
Scanning Reagents
PrimeLab 2.0 offers two options to pre-select the test to be performed, using the in-built camera:
• Tap on the camera symbol on the main menu and scan the QR-code of the reagent-pack in hand.
PrimeLab then offers you a list of parameters matching the reagent scanned. Tap on the test method
you wish to use. The ‘Test‘ menu will appear instantly, with the test method pre-selected.
• Start a test procedure by tapping the ‘Test‘ icon on main menu, then tap the camera symbol next to
the test-methods field, followed by scanning the QR- code of the reagent-pack in hand. PrimeLab
then offers you a list of parameters matching the reagent scanned. Tap on the test method you wish
to use.
Activating additional parameters
When your request for additional parameters for your PrimeLab 2.0 is approved, you will receive an
Email which contains a QR-code. Just tap on the camera symbol on main-menu and scan this QR-
code to activate the requested parameters.
Available for you soon!
PrimeLab2.0
To Next Page
Loading...
Need help?
General
