Section 3
Auto-Zone CV & CV-EX
3-8 Programming
New Passcodes
Programming Passcodes
Caution: If you change the Level 2 passcode and cannot remember what it is, you
will be locked out of your system!
Enter New Passcode
Level 1.....: XXXX
Level 2.....: XXXX
[Must Be 4 Digits]
The System Manager has two levels of user access.
Level 1 users are limited to viewing or changing Zone
Temperatures and their Heating and Cooling Setpoints, and to
viewing Unit ID numbers for those in alarm conditions.
Level 2 users have complete system access. Any status or
setpoint field can be read or reset from the Auto-Zone system.
These two levels of passcodes are programmable by any Level
2 user. The default Level 1 passcode is "1111" and the default
Level 2 passcode is "2222."
The actual digits in your passcodes are never displayed. An
"X" is used as a place holder for each digit entered. Passcodes
must always be four digits in length, so the useable range of
numbers is 1000 to 9999.
To Next Page
Loading...
