Section 3
Auto-Zone CV & CV-EX
3-10 Programming
Read/Reset Units
Read/Reset Address Entry
Read/Reset
[ Enter Unit ID# ]
Selected Unit: 101
You must know the Unit ID of the controller you wish to view.
This number is created by combining the network loop address
with the CV Controller board address on CV-EX systems. And
on CV systems it is just the CV controller board address. The
CV Controllers should always be addressed starting with
number 1 and continuing up to 30. The CV-EX MiniLinks
(network loop address) should be numbered starting with 1 and
continuing up to 4 (assuming you have 4 loops). Don’t skip
numbers.
Once you have finished the Read/Reset function, you can exit
this mode by pressing the ESC key. This will return you to the
Full Access Menu.
To Next Page
Loading...
