8.Frequently Asked Questions
and Troubleshooting (FAQ)
Should the filament replacement operation be run for operating the printer
each time?
The filament replacement operation should not be run for startup of printer
each time, but only be used in the filament replacement.
After the model is completed with printing, can it be taken down the model
by hand immediately?
Please do not get model by hand immediately, please wait the model
cooling for a moment, and gently shovel away the model by scraper (13) ; be
attention not to shovel the tape sticker (1) on the printing platform to bad.
Power indicator light is bad, how do we do?
Please check whether the power cable (4) is well connected with printer,
and the power switch on the printer is “1”, and the power button has already
been opened.
The model bottom does not stick platform, or model is moved, how do we
deal?
Please check whether it is correct for temperature set for printing platform,
and whether the printing platform has already reached the setting
temperature.
If the printing platform temperature is correct, please check whether the
printing platform (printing platform) is flat, adjust the printing platform.
To Next Page
Loading...
