49 50
GB
5.The printing nozzle is blocked and unable to feed filament material, how
do we deal?
Please check whether the filament material is used up on the reel support,
1) The filament materials are used up, which shows the filament material is
left in the printer nozzle. Please use Hex wrench 2.5mm (12) disassemble
the fan above the printing nozzle, and use Hex wrench 2mm (11) to Loosen
the screw which fixed nozzle ,take off the printing nozzle and then heat the
printer nozzle to 230°C, use tweezers (8) to pull out the filament section
carefully. Shut down the printer and re-install it after the printing nozzle
cools down.
2) The filament materials aren’t used up, which shows the printing nozzle is
blocked. Please use Hex wrench 2.5mm (12) disassemble the fan on the top
of printing nozzle, and check whether the feed gear is twined with filaments.
If there is twined filament, it cuts off the filament at the top of aluminum
block ,use Hex wrench 2mm (11) to Loosen the screw which fixed nozzle,
and removes the printing nozzle, and then heat the printing nozzle to 230°C,
Use tweezers (8) to pull out the filament section. Shut down the printer,
Unplug Motor Cable (5) cord and then take out the whole motor and feed
gear, clean the filament debris in the feed gear by tweezers (8) , and
installed is performed according reverse procedures after cleaning. If there
is no twined filament, please heat the printer nozzle to 230°C, press down
the handle of nozzle, manually input filament materials, slightly use
strength to push filament materials down, push out the filaments left in the
printing nozzle, and then take out filament materials manually, repeat
several times, until the printing nozzle is completely cleaned.
Please be carefully to dredge the printing nozzle, in order to avoid scalding.
If the printing nozzle can’t be dredged, please contact our company for
replacement of printing nozzle. The printing nozzle is replaced; it can start
to work until the printing platform is needed to adjust to flat once again.
Unable to generate Gcode Tip?
Python software has something wrong with the Installation. If user only
installed ReplicatorG , Please Uninstall the software , and install Python
To Next Page
Loading...
