,and then re-install ReplicatorG; If user has installed Python and
ReplicatorG, Please Uninstall original Python and ReplicatorG, and
re-install them. The default installation path is C drive.
After installing the print software driver, connect Print cable (3) and point
out not connect to the printer?
First make sure the printer is on, the USB connection is already seated, the
printer USB port is correct, and check whether has clicked "connect the
printer" option on the software, or failing that, you can restart your
computer to try again.
If still cannot connect, consider whether the print driver is not installed well,
or you can re-install the print software to try again
After installing the printing software, there will be an error message in the
screen:
Could not create the java virtual machine.
One possibility: The system configuration issues cause problems of java
virtual machine, the front desk software report errors without starting.
Allow customers to enter the C drive ReplicatorG installation directory, run
ReplicatorGxp .EXE and try.
One possibility: problems of the virtual memory settings. It is possible that
the consumer has set up a 5-10g virtual memory and beyond the maximum
of software identification. Selecting automatically assigned in system
Settings:
Using Netfabb software to view the model dimensions, check whether there
is a error in the model ,check whether the model there is a problem and
how to fix the problem model.
Run the software installation package, Netfabb Installer-offline, in the
installation wizard window, click “Continue” to install the software. After
installation is complete, click "Finish" to exit.
To Next Page
Loading...
