13
Print the first model
4.2. Assembly of Filament
Take out the tray and rack, put the spindle of material rack on the tray and put
all together to the material rack. Find out one end of filament from the
material tray and sent it to the feed pipe at the back board of printer, unl the
filament thread out from another end of material pipe.
Open the cover plate on theprinter; pull out the filament around 20cm from
the material pipe. Break straight the end of filament, right hand presses down
the handle of extruder, and le hand holds the filament and plug it into the
feed inlet, inseron depth is about 5cm.
To Next Page
Loading...
