WEEDO M2 - Printing Consumable Items; Environmental Requirements

Applicaon Noces
03
1.1 About The Instrucon Book
This instrucon book contains 3D printer’s installaon, use, maintenance,
common problems and other important informaon. Please read this
instrucon book carefully before use 3D printer. For 3D printer damage and
other damages caused by violaon of safety maers and operaon
procedures given in the instrucon book, it will be borne by the user.
1.2 Safety Aenons
1、In the prinng or just aer prinng of 3D printers, as nozzle temperature
reach up to 200℃, it is forbidden to touch the prinng head directly at this
moment.
2、3D printer is equipped with acve air filtraon system; it can handle the
most irritang gases emied aer heang of filaments in prinng. But if
prinng is needed for long me, please use the printer under the
well-venlated environment.
3、As 3D printer is complicated for its structure, if there is fault, please refer
to the instrucon book to eliminate the faults. If the fault sll can’t be solved,
please contact the aer-sales department of company. To the printer
maintained by user without authorizaon, the company would not guarantee
maintenance.
4、As 3D printer is equipped with high voltage inside, it is forbidden to
disassemble the printer by the non-professional staff. To any consequence
caused by violaon of this maer, it would be borne by users.
5、Please use the electric wire to connect and USB data connecng line
provided by company. Any printer’s faults and other consequences caused by
use connecng line or USB data connecng line provided by the third-party, it
would be borne by users.
6、When 3D printer power supply is connected, please insert the power cord
into the flat three holes socket in compliance with internaonal standard. It is
not allowed to insert the power cord to the two holes socket. One line of
ground wire in the power socket must be well grounded, and should not be
suspended. The mechanic fault other accidents caused by that 3D printer is
not well grounded, the company would not be responsible.
7、The default input voltage of 3D imprinter is 220V. If 3D printer is used in
the areas out of China mainland, please contact the company aer-sales, the
company technician staff would provide you soluons.
8、When the accident power outage occurs at your area, please equip the
UPS power supply of 3D printer.
1.3 Prinng Consumable Items
Use the printer, please use the prinng consumable items provided by the
company. The prinng consumable sold in the retail market is of different
specificaons and quality levels, it is very easy to block the printer nozzle and
damage the nozzle and electrical machine. For the printer faults caused by
use the consumables of third party, our company would not guarantee to
repair.
1.4 Environmental Requirements
The 3D printer is applied with fully enclosed structure, strongly adapve to
the environment temperature, and can work normally in the 5℃ to 40℃
environment. If the environment temperature exceeds this range, the prinng
quality of finished product will be dropped accordingly.
Aer the prinng consumableis opened with its package, if they are not used
for a long me, please seal it by sealed package. Especially to the PLA
consumables, it would absorb the moisture in the air to affect the quality of
prinng finished products aer long me exposure to air.