WEEDO M2 - Printer Daily Maintenance Guide; Cleaning Printing Nozzle; Replacing Printer Platform 3 M Sticker

40
Daily Repair and Maintenance
7.1. Printer Daily Maintenance Guide
The daily maintenance mainly contains: clean printer nozzle, replace the
printer plaorm scker and tape, printer plaorm regular check and leveling,
replace air filtraon core, opcal sha and screw rod maintenance and
others.
7.1.1. Cleaning Prinng Nozzle
In the process of 3D prinng, the part of consumable debris and dust parcles
is likely to accumulate around the prinng nozzle. As me goes on, these
accumulave materials can lead to that prinng precision becomes poor or
nozzle is block and others. Therefore, before prinng for each me, it needs
to observe whether the nozzle is blocked and perform the cleaning.
Maintenance method: The prinng nozzle is usually cleaned by tweezers, and
the impuries around nozzle are wiped out by the cleaning cloth.
7.1.2. Replacing Printer Plaorm 3M Scker
Check whether the blue 3M scker surface is worn and uneven on the prinng
plaorm, if scker is worn, it must be replaced, and ensure model can firmly
be pasted on the prinng plaorm.
Maintenance method: firstly find out a roll of tape scker presented in
accompany printer on the accessories box.