WEEDO M2 - Page 29

26
Cura Soware Detailed Introducon
“Layers”refers to layered mode, and can watch the movement path of
spray-head andsupport structure, as shown in figure below:
5.2.3. Generaon of Gcode Code and X3G File
Yellow arrow refers to the data which is result of model conversion, including
prinng the me-consuming and filament use volume. If the cost of filament is
set, it would display the model cost. At this moment, the buon of save can
be used, and click the buon the red arrow points, to geneGcode code.