WEEDO M2 - Page 55

FAQ
52
1.Should the filament replacement operaon be run for operang the
printer each me?
The filament replacement operaon should not be run for startup of
printer each me, but only be used in thefilament replacement.
2.Aer the model is completed with prinng, can it be taken down the
model by hand immediately?
Please do not get model by hand immediately, please wait the model
cooling for a moment, and gently shovel away the model by scraper; be
aenon not to shovel the blue 3M scker on the prinng plaorm to
bad.
3.Power indicator lighsbad, how do we do?
Please check whether the front side and back side of power switch have
already been opened, and whether the power cord is well connected.
4.The printed model boom is unstable for pasted, or model is moved,
how do we deal?
Please check whether it is correct for temperature set for prinng
plaorm, and whether the prinng plaorm has already reached the
seng temperature.
If the prinng plaorm temperature is correct, please check whether
the prinng plaorm (prinng plaorm) is flat, adjust the prinng
plaorm.
5.The prinng nozzle is blocked or can’t come out flagellaon, how do
we deal?
Please check whether the filament consumables is used up on the
feeding rack,
1）The filament materials are used up, which shows the filament
material is le in the printer nozzle. Please disassemble the fan above
the prinng nozzle, and take off the prinng nozzle and then heat the
printer nozzle to 230℃, use plier to pull out the filament secon
carefully. Shut down the printer and re-install it aer the prinng nozzle
cools down.
2）The filament materials are used up, which shows the prinng nozzle
is blocked. Please disassemble the fan on the top of prinng nozzle, and
check whether the feed gear is twined with filaments. If there is twined
filament, it cuts off the filament at the top of aluminum block and
removes the prinng nozzle, and then heat the prinng nozzle to 230℃,
Use plier to pull out the filament secon, and take away the extruder,
clean the filament and debris in the feed gear, shut down the printer,
and install the extruder and printer nozzle; if there is no twined
filament, please heat the printer nozzle to 230℃, press down the
handles of extruders, manually input the wire, slightly use strength to
push the wire down, push out the filaments le in the prinng nozzle,
and then return the wire manually, repeat several mes, unl the
prinng nozzle is completely cleaned.
Please be carefully to dredge the prinng nozzle, in order to avoid scalding.
If the prinng nozzle can’t be dredged, please contact our company for
replacement of prinng nozzle. The prinng nozzle is replaced;it can
start to work unl the prinng plaorm is needed to adjust to flat once
again.