Keypad (HMI) and Basic Programming
English
NOTE!
When the inverter is in the fault state, the main display indicates the number of
the fault in the format Fxxx. Navigation is allowed after activation of key
.
NOTE!
When the inverter is in the alarm state, the main display indicates the number of
the alarm in the format Axxx. The navigation is allowed after the activation of key
; thus, the indication “A” goes to the unit of measurement display until the
situation causing the alarm is solved.
NOTE!
A list of parameters is presented in the quick reference of the parameters. For further
information about each parameter, refer to the CFW100 programming manual.
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
