What to do if the WEG Controller motor does not run?
If your WEG Controller's motor isn't running, start by checking the power and control connections, making sure digital inputs like DIx, programmed for Enabling or External Fault, are connected to +24V. Also, verify the parameters are correctly programmed for your application. Finally, check if the Soft-Starter is disabled due to a fault condition.
Why is the display OFF on my WEG SSW-06?
If the display on your WEG Controller is off, first check the keypad connections to the Soft-Starter. Then, check the supply voltage of the control board (X1.1, X1.2 and PE), ensuring it's within the range of 93.5 Vac to 253 Vac. Lastly, inspect the fuse of the control board and replace it if it's blown.
How to fix jerking during pump deceleration on WEG Controller?
If you experience jerking during pump deceleration with your WEG Controller, it may be due to the parameter setting of the Soft-Starter. Try reducing the time set at P104.
General| Type | Soft Starter |
|---|---|
| Operating Frequency | 50/60 Hz |
| Protection Degree | IP20 |
| Control Method | Voltage Ramp |
| Protection | Overload, Phase Loss, Overvoltage, Undervoltage |
| Humidity | 95% RH non-condensing |
| Bypass Contactor | Optional |
| Communication | Optional Modbus RTU |
| Current Rating | 6A |
| Output Current | 6A |
| Operating Temperature | -10°C to 50°C |
To Next Page
