Wega EVDS io - 1.3 Instruction Manual Updates; 1.4 Target Audience Identification; 1.5 Glossary and Pictograms; 1.6 Guarantee Information

30
User manual
1.3 Method for updating the Instruction
Manual
The Manufacturer reserves the right to modify and make
improvements to the machine without providing notice or up-
dating the Manual that has already been received by the user.
Moreover, when substantial changes made to the machine
require the modication of one or more chapters of the Instruc-
tion Manual, the Manufacturer will send users the chapters
aected by the changes or a revision of the entire Manual.
It is the users’ responsibility to replace the old document
with the new revision.
The Manufacturer is responsible for the Italian content.
Translations cannot be fully veried; therefore, in the event
of inconsistency, users can refer to the Italian version or if
necessary, contact the Manufacturer who will make the ap-
propriate changes.
Should the Manual become illegible or otherwise hard to read,
the user must request a new copy from the Manufacturer before
carrying out any work on the machine.
It is absolutely forbidden to remove or rewrite parts of the Manual.
The instructions, drawings and documentation contained in this
manual are condential and the sole property of the Manufacturer.
They may not be reproduced in any way, either in full, or in part
without prior authorisation.
Users are responsible for complying with the instructions
contained in this Manual.
Should any incident occur as a result of incorrect use of these
recommendations, the Manufacturer declines any liability.
This manual is also available on the manufacturer’s website.
1.4 Recipients
This Manual is addressed to the machine’s User,
namely, the person in charge of operating, maintaining
and cleaning the machine described in this document.
MACHINE RECIPIENT QUALIFICATIONS
The machine is intended for a professional non-
generalised use, so it is to be used by trained people,
and particularly those who:
• Are aged 18 and over;
• Are physically and mentally capable of using the
machine;
• Are able to understand and interpret the Instruction
Manual and safety requirements;
• Know the safety procedures and how they are imple-
mented;
• Are able to use the machine;
• Have understood the procedures of use as dened
by the machine’s Manufacturer.
1.5 Glossary and Pictograms
This paragraph lists uncommon terms or terms whose
meanings are dierent from those most commonly used.
Abbreviations are explained below, as well as the
meaning of pictograms describing the operator’s quali-
cation and the machine status; they are used to quickly
and uniquely provide the information needed to cor-
rectly and safely use the machine.
1.5.1 GLOSSARY
User
The person or persons in charge of operating, main-
taining and cleaning the machine described in this
manual.
Manufacturer’s Qualied Technician
A person specially trained and qualied to connect,
install and assemble the machine; use special equipment
(hoists, forklifts, etc.); perform routine or unscheduled
maintenance that may be particularly complex or po-
tentially dangerous if performed by the user; and, pay
special attention to safety and hygiene issues.
All other glossary entries are listed in Chap. “14 GLOSSARY” page
45.
1.5.2 PICTOGRAMS
PICTOGRAM DESCRIPTION
Electrical hazard
High temperature hazard
The use of protective gloves is mandatory
It is mandatory to read the documentation
1.6 Guarantee
All of the machine’s components are covered by a
12-month guarantee, except for electrical and electronic
components and parts prone to wear and tear.