Wega Polaris 1GR User Manual

47
Polaris
ENGLISH
User manual
9 Preparing the coee
9.1 EMA version
t Place the coee cup under the dispensing spout;
t lift up the lever: the delivery will begin, and it
can be stopped using the same switch once the
desired amount of coee is obtained in the cup.
9.2 EPU version
t Place the coee cup under the dispensing spout;
t press the desired dispensing switch. Dispens-
ing will begin, and it can be stopped using the
same switch once the desired amount of coee
is obtained in the cup.
Coee
delivery
Coee
delivery
9.3 EVD version
Programming coee dose
Always program the right push-button panel rst,
and, if necessary, the others subsequently.
t Place the coee cup under the dispensing spout;
t press the STOP/PROG. button and keep it pres-
sed for 5 seconds: all the push-button panel’s
leds will light up;
t press the dose button to be programmed (e.g.
1 espresso);
t wait for the dispensing. To conrm the dose,
press the dose button or the STOP/PROG. but-
ton again ;
t repeat this operation for the other dose buttons;
t Upon the completion of programming, press the
STOP/PROG. button until all the push-button
panel’s leds shut o.
STOP
PROG.
1
Espresso
(Mode)
1 Large
coee
( + )
Stop/
Continuous/
Programming
2
Espressos
(Enter)
Manual
dispensing
2 Large
coees
( - )
i
Programming of each dose must be carried out
with ground coee and not with previously used
grounds.
i
It is possible to program all machine’s push-button
panels simultaneously using only the left push-
button panel. To obtain different doses for the
various groups, perform the programming with
the left push-button panel rst, and then with all
the others.
!
Do not remove the lter-holder from the delivery
group during coee delivery.

Wega Polaris 1GR Specifications

General

Brand	Wega
Model	Polaris 1GR
Category	Coffee Maker
Language	English