WEIGL ProCommander AX - ProCommander AX Wi-Fi Configuration; Setup Wi-Fi Configuration

43
ProCommander
®
AX Wi-Fi Configuration
5 ProCommander
®
AX Wi-Fi Configuration
The configuration of the ProCommander
®
AX Wi-Fi is
similar to the setup of a typical IOT device. First connect to the
ProCommander
®
AX setup SSID and then add our preferred
WLAN to the other WLAN profiles. Up to five WLAN profiles
can be stored in a Wi-Fi module of a ProCommander
®
AX.
5.1 Setup Wi-Fi Configuration
For configuration of the Wi-Fi settings you can use the
ProCommander
®
AX Wi-Fi web interface. Therefore you
have to connect the ProCommander
®
AX via Wi-Fi with your
computer, scan for the "ProCommander_AX" Wi-Fi, which is
by default a combination of "PC_AX" and the serial number
of your ProCommander
®
AX, which can be found on the label
underneath the device or via the Weigl Configurator in the line
"Serial Number: XX.XX.XX.XX". The password is "PASSWORD"
by default. After establishing a Wi-Fi connection, open up a web
browser and type "192.168.1.1" into the URL.
The username is "admin" and the password is "PASSWORD"
by default.