WEIGL ProCommander AX - Page 64

64
Control.ini
3
rd
line: If the value of variable 1 is equal 0 (!vcc1=0), then
the output 1 to 4 will be cleared (!ess0000).
4
th
line: If the value of variable 1 is equal 1 (!vcc1=1), then
the output 1 will be activated and output 2 to 4 will be cleared
(!ess1000).
5
th
line: If the value of variable 1 is equal 2 (!vcc1=2), then
the output 1 and 2 will be activated and output 3 to 4 will be
cleared (!ess1100).
6
th
line: If the value of variable 1 is equal 3 (!vcc1=3), then
the output 1 to 3 will be activated and output 4 will be cleared
(!ess1110).
7
th
line: If the value of variable 1 is equal 4 (!vcc1=4), then
the all four outputs will be activated (!ess1111).
8
th
line: If the value of variable 1 is equal 4 (!vcc1=4), then
the value of variable 1 will be set to zero (!vmc1=0).