上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
15 / 53
1. Alpha-numeric keys
Used to input characters and numbers. Its use is generally the same with that of
the computer keyboard:
– Press an alphabet key to enter the alphabet on the right-lower part.
– Press Shift key and an alphabet key to enter the alphabet on the left-
upper right.
2. Keys for mode selection
Used to select a machining mode among Auto, JOG, Handle, Step and
REF.Point.
JOG, Handle, Step are referred as Manual mode.
3. Functional keys
There are altogether 6 functional areas, including Gen. (machining), Adv.
(advanced), Prog. (program), Sys (system), Para. (parameter) and Diag.
(diagnosis) keys.
You can access the functional area by directly pressing corresponding key.
4. Keys for tool magazine
Used to check the current tool number, pocket number, and execute operations
related to tool magazine.
Note: ATC CW and ACT CCW keys are valid only when Circular Tool Magazine is enabled.
5. Keys for adjusting step length
Used to adjust step length or override for its own handwheel.
X1, X10, X100 and XUD keys represent 0.001, 0.01, 0.1 and customized step
length separately.
6. Keys for axis direction
Used to manually move each axis.
In Manual mode:
– Press an axis direction key and Rapid key. The machine tool moves at
rapid jog speed.
– Press an axis direction key. The machine tool moves at jog speed.
7. Keys for spindle control
Used to control the spindle movement, including CW, STOP and CCW keys,
adjust spindle override, and customize extension function, including K1, K2
and K3 keys.
To Next Page
Loading...
