WEIHONG NK300CX - Main Software Interface

上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
21 / 53
1.6 Main Software Interface
The interactive user interface for NK300CX integral software in AUTO mode is as
follows:
1. Status bar
It shows the following information:
– Current mode, such as Auto, JOG, Step, etc.
– Current status of the machine tool, such as RUN, IDLE, etc.
– Name of the loaded program file.
– Machining time.
2. Information bar
It shows information, such as machining process, alarms, etc.
3. Functional area
It shows child interfaces corresponding to each main functional keys.
4. Functional keys
It show commands corresponding to F1 ~ F8 operation keys.
It differs with the child interfaces.