上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
13 / 53
11. Spindle override knob
Used to adjust spindle override from 50% to 150%.
When parameter N72003 G00 F Fixed is set to No, the knob is used as G00
override knob and used to adjust G00 override from 0 to 100%.
12. Feed override knob
Used to adjust feed override from 0 to 120%.
1.3.2 Mounting Dimension (Unit: mm)
WH108C Dimension
WH108C Cut-out
1.4 WH208A1 Operation Panel
This part introduces the layout and mounting dimension of WH208A operation
panel used by NK300CX for Drilling.
To Next Page
Loading...
