上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
49 / 53
After setting, you can check the start line and end line of the loaded program file at
the top of each interface and in Machining interface under functional area:
3.7 Execute Machining
This operation is used to run the program form the beginning to the end until the
end of block or any intentional interruption.
In AUTO mode, press .
The system automatically starts machining.
During machining, you can do one of the following to control machining:
• To stop machining, press .
• To pause machining, press .
To Next Page
Loading...
