上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
41 / 53
3.3 Adjust the WCS
In programming, programmers select a certain given point on workpiece as origin
(also called program origin) to establish a new coordinate system (i.e. workpiece
coordinate system (WCS)). This operation is used to adjust the WCS.
To adjust the WCS, do the following:
1. To enter into Coor Manager interface, in Auto mode, press → 1:
2. Optional: Select a WCS.
Parameter N62023 Ignore Coordinate System Instruction (G code files) or
N65212 Ignore Coordinate System Instruction (ENG files) decides whether
the system automatically reads the WCS command in G code / ENG files:
– When it is set to Yes, this step is required, because the system ignores
the WCS commands in G code / ENG files.
– When it is set to No (default setting), you can skip the step, because the
system automatically reads the WCS command in G code / ENG files.
3. Set the offsets.
To Next Page
Loading...
