上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
37 / 53
2. Press H. Browse for Folder dialog box pops up:
3. Select Network → target PC, find the desired shared folder, and click OK. File
list in the shared folder shows in Network interface.
4. To select the target program file, press ↑ or ↓.
5. To load the target program file for machining, press F1.
You can also do the following for a shared program file from the internet:
• F5: unload the loaded program file.
• F8: copy the target program file into NK300CX.
3.2 Execute Tool Calibration
This operation is used to measure the selected tool, so as to ensure it works
normally during machining.
Types of tool calibration includes the following:
• Mobile calibration
• Fixed calibration
• First-time calibration or calibration after tool changed: default setting
This operation mainly focuses on the last two types of tool calibration.
To set the type of tool calibration, press → 1 → F8, input the manufacturer
password, and modify the value of parameter Calibration Type.
To Next Page
Loading...
