上海维宏电子科技股份有限公司
SHANGHAI WEIHONG ELECTRONIC TECHNOLOGY CO., LTD
40 / 53
3. Do one of the following according to the actual situation:
– If it is the first time to execute calibration, pressF1. The system starts to
execute first calibration and automatically records current Z-axis
machine coordinate.
– After tool change or tool break, press F2. The system starts to execute
calibration after tool changed and automatically recovers Z-axis
workpiece coordinate of the current point.
Note: Calibration after tool changed must be executed after completion of first-time calibration.
The system automatically records the calibration results into the tool offset:
• First-time calibration
• Calibration after tool changed
To Next Page
Loading...
